Tracker 4x2 L4-1590cc 1.6L (1991)
10.
Remove button and spring by applying slight upward force while pulling button out of buckle assembly (see Figure 7). BUTTON AND SPRING
WILL NOT BE REUSED.
11.
Inspect buckle assembly for dirt, dust or foreign material. If buckle is contaminated with any form of sticky material, replace both buckle
assemblies. DO NOT ATTEMPT TO CLEAN BUCKLE OF STICKY MATERIAL.
12.
Remove any loose dirt, dust or foreign material using a dry compressed air. BE CAREFUL NOT TO DAMAGE OR DISLODGE ANY PARTS
DURING THIS PROCESS. SAFETY GOGGLES MUST BE WORN DURING THIS STEP.
13.
Check for proper position of the ejector mechanism, springs and rails (see Figure 8 ).