Tracker 4x2 L4-1590cc 1.6L (1991)
4.
Park/lock cable from gear selector lever (Figure 2).
A.
Loosen two cable nuts and remove cable from guide bracket.
B.
Cable from slot in manual release plate.
5.
Park/lock cable from vehicle.
Install or Connect
1.
Park/lock cable to gear selector lever.
2.
Park/lock cable to ignition switch lock cylinder; secure with screw at bracket and C-clip at cable end.
Adjust
^
Position gear selector lever in "P" (PARK).
^
Turn ignition key to the "LOCK" position.
^
Reinstall manual release knob.
^
Pull knob and hold.
^
Make sure cable is not bent.
^
Loosen cable nuts and pull cable toward the front of the vehicle until the manual release plate is all the way forward.
^
Tighten cable nuts so they are flush with the guide bracket.
^
Release manual release knob. Unscrew and remove.
IMPORTANT
^
Make sure that the ignition key cannot be turned from "ACC" to "LOCK" when the gear selector lever is in any position other than "P"
(PARK). If it can, that means the cable was pulled forward too far during adjustment. Readjust cable.
^
With the gear selector lever in "P" (PARK), make sure that the ignition key can be turned from "ACC" to "LOCK" and back. If it cannot, the
cable was not pulled forward far enough during adjustment. Readjust cable.
3.
Console cover (two screws, two push pins).
4.
Manual release knob.
5.
Steering column upper and lower covers (six screws).
6.
Battery negative (-) cable.
