Tracker 4x4 L4-1.6L SOHC TBI (1994)
Air Bag Control Module: Service and Repair
Prior to performing replacement procedures, disarm air bag system. Refer to, Service and Repair/ Air Bag System Disarming & Air Bag
System Arming. Refer to, / Specifications/ Mechanical for torque values when installing components.
All sensors and mounting bracket bolts must be carefully torqued to assure proper operation. Never power up the air bag system when any
sensor is not rigidly attached to the vehicle, since the sensor could be activated when not attached, causing air bag deployment.
1. Disconnect battery ground cable.
2. Remove rear and then front console to access SDM.
3. Disconnect connector assurance and electrical connector.
4. Remove attaching screws from SDM.
5. Remove SDM from vehicle.
6. Reverse procedure to install.
