Tracker 4x4 L4-1.6L VIN 6 (1995)
a. Apply a coating clean engine oil to camshaft.
b. Camshaft carrier caps are marked with numbers and directional arrows.
c. Number one cap is installed at the front of cylinder head with arrow pointing toward the front of cylinder head.
d. Install remaining carrier caps in numerical order with arrows facing toward front of cylinder head.
e. Apply RTV silicone rubber sealant to bottom of number six carrier cap.
Fig. 35 Camshaft Carrier Cap Bolt Tightening Sequence.
f.
Gradually tighten camshaft carrier cap bolts in order,Fig. 35, to specification.
2. Apply clean engine to camshaft seal, then install seal in cylinder head flush with carrier surface.
3. Install timing belt inside cover to cylinder head and tighten to specification.
4. Install rocker arm shaft plug into cylinder head and tighten to specification.
Fig. 36 Camshaft Timing Belt Gear Alignment.
5. Align dwell pin with slot in camshaft timing belt gear, Fig. 36, then using tool No. J41840, or equivalent, install camshaft timing belt gear on
camshaft and tighten to specifications.
