Tracker 4x4 L4-1590cc 1.6L (1993)
10.
Reconnect negative battery cable.
11.
Install fuel pump relay and tighten fuel filler cap. Start engine and check for leaks.
FUEL PRESSURE GAUGE REMOVAL:
1.
Loosen fuel filler cap to relieve fuel tank pressure.
2.
Remove fuel pump relay.
3.
Crank engine and allow to stall. Crank engine for an additional 3 seconds to assure relief of any remaining fuel pressure.
4.
Disconnect negative battery cable.
5.
Raise vehicle.
6.
Remove J 34730-1 fuel pressure gauge and J 37746 fuel pressure gauge adapter from fuel filter. Use a shop towel to catch any remaining fuel that
may leak.
7.
Install fuel filter inlet hose plug.
8.
Lower vehicle.
9.
Reconnect negative battery cable.
10.
Install fuel pump relay and tighten fuel filler cap.
11.
Turn ignition switch to "ON" and then to "OFF." Check for any fuel leaks.
Part 2 of 2
Chart A-7B (Part 2 Of 2)
