Acadia FWD V6-3.6L (2007)
1. Remove the upper intake manifold cover.
2. Pull each end of the hood rear seal away from the cowl panel flange near both strut towers.
3. Install three J-28467-13 (1) and two J 28467-5 strut tower adapters (2) to the top of the left and right strut tower.
4. Install a 127 cm (50 in) engine support fixture cross bar J 28467-B (3) transversely across the vehicle between both J 28467-5 strut tower adapters
(2).
5. Insert safety pins J 28467-10 (4) through the J 28467-5 strut tower adapters (2) and the cross bar (3) to prevent movement.
6. Install the engine support bracket J 42451-1 to the engine.
Notice: Refer to Fastener Notice.