Acadia FWD V6-3.6L (2007)
Remove the window from the urethane adhesive.
-
Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
-
The only suitable lubrication is clear water.
-
Use J 24402-A, J 39032, or equivalent to remove the window.
9. IMPORTANT: Keep the cutting edge of the knife/tool against the window. Do this from inside the vehicle.
If necessary, use a long utility knife or similar tool to remove the bottom corners of the windshield from the urethane adhesive.
10. With the aid of an assistant (2), remove the windshield (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the windshield into the opening.
2. Install the rearview mirror.
3. Install the interior windshield pillar garnish moldings.
4. Install the air inlet grille.
5. Install the windshield wipers arms and blades.
6. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
7. Close the hood.
Windshield Reveal Molding Replacement
WINDSHIELD REVEAL MOLDING REPLACEMENT
The windshield reveal molding is an applied molding design separate from the window. The reveal molding is bonded to the windshield and may be
bonded to the body. The reveal molding may be replaced with the windshield as an assembly, or the reveal molding may be available as a separate
service part. Refer to Adhesive Installation of Windshields.
