C 1500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1997)
2. Blower motor flange screws.
Tighten
-
Blower motor flange screws to 1.4 Nm (12 lb in).
3. Blower motor cooling tube.
4. Blower motor cover.
5. Bolt to right lower I/P support.
6. Electrical connectors to blower motor, as necessary.
7. Right hinge pillar trim panel.
8. Front screw into front door sill plate.
9. Instrument panel storage compartment.
10. Negative battery cable.
-
Check circuit operation.
Auxiliary Heating System
Auxiliary Blower Motor/Resistor
Remove or Disconnect
1. Negative battery cable.
2. Right rear quarter trim panel cover.
3. Electrical connection, as necessary.
4. Screws.
-
Position blower motor in order to remove blower motor fan.
5. Blower motor fan retaining nut.
6. Blower motor fan.
7. Blower motor.
Install or Connect
1. Blower motor.
2. Blower motor fan.
3. Blower motor fan retaining nut.
4. Screws.
Tighten
Screws to 1.4 Nm (12 lb in).