C 1500 Truck 2WD V6-4.3L VIN W (2001)
28. Install the radiator inlet hose to the thermostat housing.
29. Refill the cooling system.
30. Position the engine wiring harness and the engine wiring harness brackets.
31. Install the stud at the rear of the right cylinder head for the engine wiring harness bracket.
^
Tighten the engine wiring harness bracket stud to 25 Nm (18 ft. lbs.).
32. Install the nut holding the engine wiring harness bracket to the EVAP purge canister solenoid stud.
^
Tighten the engine wiring harness bracket nut to 9 Nm (80 inch lbs.).
33. Install the nut and the ground wire to engine wiring harness bracket stud at the rear of the right cylinder head.
^
Tighten the ground wire nut to 16 Nm (12 ft. lbs.).
34. Install the nuts and the engine wiring harness bracket to the upper intake manifold studs.
^
Tighten the engine wiring harness bracket nuts 12 Nm (106 inch lbs.).
