C 1500 Truck 2WD V6-4.3L VIN W (2001)
Removal Procedure
Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
1. Remove the power steering inlet hose (2) from the power steering pump (1).
2. Remove the power steering inlet hose (2) from the power steering gear (3).
Installation Procedure
1. Connect the power steering inlet hose (2) to the power steering gear (3).
Notice: Refer to Fastener Notice in Service Precautions.
2. Connect the power steering inlet hose (2) to the power steering pump (1).
-
Tighten the hose connections; to 28 Nm (20 ft. lbs.)
3. Bleed the power steering system. Refer to Bleeding the Power Steering System.
4. Inspect all the hose connections for leaks.
Without Hydroboost
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.