C 1500 Truck 2WD V8-350 5.7L (1989)
10.
Install a new spring (Figure 1, Item 2).
11.
Install a new door handle pin.
12.
Reconnect control rods to the handle and lock assembly and secure the remote control assembly to door module with six rivets.
13.
Reinstall the door trim panel and arm rest.
14.
Reinstall the power lock and door handle bezel.
15.
Vehicles without power locks and/or windows, reinstall the door control switch panel assembly. If equipped with power locks and/or windows,
reinstall the door control switch panel assembly and reconnect the electrical connection.
16.
Reconnect negative battery cable.
PARTS INFORMATION
P/N
Description
Qty
12383517
Spring Kit-Front Side Door
1/Door
Interior Handle
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty, use:
Labor
Operation
Description
Labor Time
B4332
R & R Interior Door Handle Spring, RH
0.6 hr
B4333
R & R Interior Door Handle Spring, LH
0.6 hr
Technical Service Bulletin # 9110174
Date: 920101
Door Handle (Interior) - Rattles
GMC NUMBER:
91-10-174
GROUP:
1OA1 Doors
DATE:
January 1992
CORPORATE
NUMBER:
161604
SUBJECT:
INTERIOR DOOR HANDLE RATTLE (INSTALL REVISED CONTROL ASSEMBLY)
MODELS:
1988-1991 C/K VEHICLES
Some 1988-1991 C/K trucks may experience an interior door handle rattle due to an over travel condition when the door handle is released or when the
door is slammed. The over travel causes the lower flange of the door handle to strike the bezel.
To correct this condition, it will be necessary to replace the inner door handle housing for the interior door handle. The revised inner door handle
housing reduces the size of the lower flange on the handle. This reduction in the size of the flange provides the necessary clearance to the bezel, thereby
eliminating the door rattle.
Before performing the following service procedure, it is necessary to make sure that the actual cause of the rattle is the inner door handle. To do this,
wrap a piece of cloth around the door handle and release the door handle. If the rattle stops, it is likely that the rattle can be eliminated by installing the
revised inner door handle housing.
SERVICE PROCEDURE: