C 1500 Truck 2WD V8-4.8L VIN V (2000)
Steering Gear: Adjustments
Worm Thrust Bearing Preload Adjustment (Off Vehicle)
-
Tools Required
-
J 42882 Adjuster Nut Socket
-
J 43435 Adjuster Lock Nut Wrench
1. Rotate the stub shaft back and forth in order to drain the power steering fluid.
2. Remove the coupling shield retainer and the lock nut from the steering gear housing using J 43435 and a torque wrench.
Notice: Refer to Fastener Notice in Service Precautions.
3. Turn the adjuster nut assembly (1) clockwise using J 42882 until the adjuster nut assembly (1) and the thrust support assembly (2) are firmly
bottomed in the steering gear housing (3).
-
Tighten the adjuster nut assembly (1) to 28 - 31 Nm (20 - 23 ft. lbs.).
4. Place an index mark (1) on the steering gear housing (4) parallel with one of the holes (3) in the adjuster nut assembly (2).