C 1500 Truck 2WD V8-4.8L VIN V (2000)
3. Install the plug (2).
4. Install the retaining ring (1). Ensure that the retaining ring open end is approximately 25 mm (1 inch) from the access hole in the steering gear
housing (5).
700 Gear
Disassembly Procedure
1. Loosen and remove the adjuster lock nut (1).
2. Remove the bolts (2).
3. Rotate the stub shaft (6) using a 12-point socket to center the steering gear (7).
4. Remove the following items as an assembly:
-
The side cover (8)
-
The gasket (3)
-
The pitman shaft (4)
5. Remove the pitman shaft (4) from the side cover (8).
Assembly Procedure
1. Screw the pitman shaft (4) to the side cover (8) until it fully seats to the side cover (8).
2. Install the adjuster lock nut (1). Do not tighten the adjuster lock nut (1) until the pitman shaft adjustment is completed.
3. Install the gasket (3) to the side cover (8).
4. Bend the gasket tabs around the edges of the side cover (8).
5. Install the pitman shaft assembly (4) and the side cover (8) to the steering gear housing (7).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the bolts (2).
-
Tighten the bolts (2) to 60 Nm (45 ft. lbs.).
7. Refer to Pitman Shaft Over-Center Preload Adjustment - Off Vehicle to adjust the pitman shaft (4).