C 1500 Truck 2WD V8-4.8L VIN V (2000)
1. Grease the stub shaft seal with the special grease supplied with the new stub shaft housing.
2. Install the new stub shaft housing retaining ring (1) onto the steering gear housing.
3. Install the new stub shaft housing O-rings (2) (3).
4. Install the stub shaft housing (4) onto the steering gear.
Notice: Refer to Fastener Notice.
5. Install the stub shaft housing bolts (5) into the stub shaft housing (4).
-
Tighten the stub shaft housing bolts to 55.0 - 70.0 Nm (40.5 - 51.6 ft. lbs.).
Tie Rod End Replacement - Outer
For information regarding the service and repair of this component, and the system that it is a part of, Please refer to Tie Rod End.
Tie Rod Replacement - Inner
For information regarding the service and repair of this component, and the system that it is a part of, Please refer to Tie Rod In Steering.