gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Instrument Panel Compartment - Rattle Noise|Page 12989 > < Trailer Hitch|Locations|Page 12979
Page 1
background image

Accessory Compartment: Customer Interest
Instrument Panel Compartment - Rattle Noise

File In Section: 8 - Chassis/Body Electrical 

Bulletin No,: 86-83-09

Date: February, 1999

Subject:
Rattle Noise in Instrument Panel Compartment 
(Replace Instrument Panel Compartment Striker)

Models:
1999 Chevrolet Silverado and GMC Sierra Models

Condition

Some owners may comment about a rattle noise coming from the instrument panel (IP) compartment. This noise may be more noticeable traveling in
rough road conditions.

Cause

The condition may be caused from improper latch to striker preload, causing a loose fit at the striker connection.

Correction

A new IP compartment striker has been developed to correct this condition. Replace the striker on affected vehicles. Use the part number listed below.

Use the following Service Procedure.

Removal Procedure

1.

Lower the IP compartment door.

2.

Remove the two screws that attach the striker to the IP compartment (Figure 1).

3.

Remove the striker.

Installation Procedure

1.

Attach the striker to the IP compartment.

2.

Install the two striker screws (Figure 1). Tighten

Instrument Panel Compartment - Rattle Noise|Page 12989 > < Trailer Hitch|Locations|Page 12979