C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
9. Install the right mounting bracket to the engine front cover.
10. Install the generator to the mounting bracket.
11. Install the vacuum pump to the mounting bracket.
12. Install the fuel injection pump mounting bolts.
13. Install the water pump to the engine block.
IMPORTANT: Check the marks on the fuel line clips made during removal. Ensure that the fuel line clips are re-installed on the proper studs.
14. Install the fuel pump drive gear to the camshaft and align the timing marks.
Tighten the bolts to 25 Nm (20 ft. lbs.).
15. Install the fuel return line clips.
16. Install the crankshaft position sensor to the engine front cover.
17. Install the crankshaft balancer to the crankshaft.
18. Install the lower fan shrouds to the radiator.
19. Lower the vehicle.
20. Install the drive belt on the pulleys.
21. Install the upper fan shroud to the radiator.
22. Connect the battery negative cables to the batteries.
23. Refill the cooling system.
24. Reset the fuel injection pump timing.
25. Perform the TDC offset timing procedure.
