C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
Seals and Gaskets: Service and Repair
REMOVAL PROCEDURE
1. Raise and support the vehicle.
2. Remove the propeller shaft.
3. Remove the rear extension oil seal.
INSTALLATION PROCEDURE
-
Required Tools
-
J21426 Rear Extension Seal Installer
1. Install the new seal using J21426.
2. Coat the outer edge of the seal case with a non-hardening sealer.
3. Install the propeller shaft. Refer to one of the following as appropriate:
-
Propeller Shaft Replacement (Front Axle-All Except NP8) in Driveline/Axle.
-
Propeller Shaft Replacement (Front Axle-NP8) in Driveline/Axle.
-
Propeller Shaft Replacement (System Balanced Assembly) in Driveline/Axle.
-
Propeller Shaft Replacement-One-Piece in Driveline/Axle.
-
Propeller Shaft Replacement-Two-Piece in Driveline/Axle.
-
Propeller Shaft Replacement-Three-Piece in Driveline/Axle.
4. Lower the vehicle.
5. Fill the transmission to the proper level with Dexron (R) III Transmission Fluid.