C 1500 Yukon 2WD V8-4.8L VIN V (2000)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor Replacement (Dual Tanks)
REMOVAL PROCEDURE
CAUTION: Refer to the Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure (Pickup) or Fuel Tank Draining Procedure (Utility with Single Tank) or Fuel
Tank Draining Procedure (Utility with Dual Tanks - From Tank) or Fuel Tank Draining Procedure (Utility with Dual Tanks - Rear
Tank).
4. Remove the fuel tank.
5. Remove the fuel pressure sensor (1).
INSTALLATION PROCEDURE
1. Install the fuel pressure sensor (1).
2. Install the fuel tank.
3. Refill the fuel tank.
4. Install the fuel filler cap.
5. Connect the negative battery cable.
6. Inspect for leaks.
6.1. Turn the ignition ON for 2 seconds.
6.2. Turn the ignition OFF for 10 seconds.
6.3. Turn the ignition ON.
6.4. Inspect for fuel leaks.