C 1500 Yukon 2WD V8-5.3L VIN Z Flex Fuel (2003)
![background image](/gmc/c_1500_yukon_2wd/v8-5.3l_vin_z_flex_fuel/Page-3522004.png)
2. Remove the windshield garnish molding.
INSTALLATION PROCEDURE
1. Ensure the bottom of the molding is seated in the slots on the I/P.
2. Align the molding retainers to the slots.
3. Press the moldings straight in till fully seated.
Garnish Molding Replacement - Center Pillar
Garnish Molding Replacement - Center Pillar
Removal Procedure
1. Remove the door sill plates.
2. Remove the pillar moldings by holding the moldings firmly while pulling out.
Installation Procedure
1. Install the pillar moldings by pushing until the molding locks into place.
2. Install the door sill trim plates.
Garnish Molding Replacement - Lift Gate
Garnish Molding Replacement - Lift Gate
Removal Procedure