C 1500 Yukon 2WD V8-5.3L VIN Z Flex Fuel (2003)
7.
Install the new nut to the upper ball joint stud.
Tighten
Tighten the nut to 50 N.m (37 lb ft).
8.
Install the retaining bolts for the brake hose and wheel speed sensor brackets.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
9.
Connect the ESC link rod to the sensor, if equipped. Refer to Front Position Sensor Link Assembly Replacement - Electronic Suspension in
Electronic Suspension Control.
10.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11.
Remove the safety stands.
12.
Lower the vehicle.
13.
Verify the wheel alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
Upper Control Arm Replacement (H2)
Tools Required
J 42188-B Ball Joint Separator
Removal Procedure
1.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2.
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.