C 1500 Yukon 2WD V8-5.3L VIN Z Flex Fuel (2003)
*
The underside of the rear defogger bus bar lead wire
*
The defogger terminal
7. Align the spots with the flux to the appropriate areas:
*
The underside of the rear defogger bus bar lead wire
*
The defogger terminal
8. Coat the tip of the soldering iron with solder.
9. Solder the appropriate areas:
*
The underside of the rear defogger bus bar lead wire
*
The defogger terminal
10. Draw the iron across the fluxed spot. Thinly coat the spot with solder.
11. Solder the spot on the braid against the spot on the feed bus bar or the ground bus bar.
12. Use pliers in order to hold the appropriate component:
*
The rear defogger bus bar lead wire
*
The defogger terminal
13. Apply heat to the appropriate area in order to ensure the solder spot melts and fuses together:
*
The top of the rear defogger bus bar lead wire
*
The defogger terminal
Important: Do not remove the holding force until the solder has solidified.
14. Remove the excess flux with the solvent.
15. Connect the electrical connector.
Stationary Window Reveal Molding Repair
STATIONARY WINDOW REVEAL MOLDING REPAIR
REMOVAL PROCEDURE
1. Lift up on the loose area of the reveal molding.
CAUTION: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.
IMPORTANT: The window reveal molding fills the cavity between the body and window. If the reveal molding is stretched or damaged, it cannot
be reused and it must be replaced.
2. Clean the top edge of the window surface and the reveal molding with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened
lint-free cloth.
3. If the reveal molding cannot be reused, refer to Stationary Window Reveal Molding Repair.
INSTALLATION PROCEDURE