C 2500 3/4 Ton Pickup 2WD V8-350 5.7L VIN M 4-bbl (1984)
Clutch Pedal Assembly: Adjustments
Fig. 2 Clutch pedal adjustment. 1980---84 C & K models & 1980---87 P models
1980---84 C & K MODELS & 1980---87 P MODELS EXC. 157 INCH WHEEL BASE P30/3500 & MOTOR HOME
1.
Disconnect return spring at clutch fork.
2.
Position clutch lever firmly against rubber bumper on brake pedal bracket.
3.
Push outer end of fork rearward until release bearing lightly contacts pressure plate.
4.
Loosen locknut and adjust rod length so that swivel slips freely into gauge hole, Fig. 2. Increase length until all lash is removed from linkage.
5.
Reinstall rod into lower hole on lever. Install two washers and cotter pin. Tighten locknut without changing rod length.
6.
Reinstall return spring and check pedal travel. Pedal travel should be 1-3/8 to 1-5/8 inch on C-K models; and 1-1/4 to 1-1/2 inch on P models.
157 INCH WHEEL BASE P30/3500
1.
Disconnect return spring from clutch fork.
2.
Loosen nut ``G'' at swivel, Fig. 2.
3.
Move clutch fork rod against fork to eliminate play between release bearing and clutch.
4.
Position clutch lever against rubber stop on brake pedal bracket.
5.
Rotate fork rod until a clearance of 1/4 to 5/16 inch is obtained between shoulder fork rod and the adjustment nut.
6.
Tighten nut ``G'' against swivel and install return spring.
7.
Check free pedal clearance at pedal. Pedal clearance should be 1-3/8 to 1-5/8 inch.
