C 2500 Suburban 2WD V8-350 5.7L VIN K TBI (1995)
INSPECTION PROCEDURE - (FIGURE 1)
The vehicles involved have front seat belt assemblies that have an energy management loop system which are covered by a plastic sleeve. To properly
identify the retractor assemblies that are involved in the bulletin, follow the inspection procedure listed.
1.
Open the driver/passenger door for 1994 vehicles; passenger door only for 1995 vehicles. Locate the seat belt retractor assembly portion of the
seat belt (installed at the "B" pillar).
-
For the retractor assembly that has 2 plastic sleeves (1 attached to the shoulder and 1 attached to the lab belt webbing) (Figure 1, Item 1),
continue on in the bulletin for proper service procedures that need to be performed.
-
For the retractor assemblies that have a single plastic sleeve on the shoulder belt webbing only, or has no plastic sleeves (Figure 1, Item 2), NO
REPAIR IS REQUIRED. A campaign Identification Label should be installed at this time.
SERVICE PROCEDURE "A"
For 1994-1995 C/K With RPO L49 (VIN Code P) and RPO L56 (VIN Code S) Diesel Engines Only
This procedure addresses removing the Seat Belt Retractor Assembly on 1994-1995 C/K With RPO L49, (VIN Code P) and RPO L56 (VIN Code S)
Diesel Engines Only:
*
For 1994 models: Replace both Driver and Passenger Side Retractor Assembly.
*
For 1995 models: Replace the Passenger Side Retractor Assembly ONLY.