C 2500 Suburban 2WD V8-350 5.7L VIN K TBI (1995)
Important
Only apply enough sealant to fill the groove in the cover.
9.
Install the new cover on the wiper motor housing and install the three new screws.
Tighten
Tighten the screws to 2.6 Nm (23 lb in).
10.
Reconnect the wiper motor electrical connector to the wiper motor assembly and install the CPA.
11.
Turn the ignition key to the ON position and check the wiper system for proper operation (delay/low/high/etc.).
12.
Install the GM Recall Identification Label.