C 2500 Truck 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Sensor electrical connector.
3. Sensor bolt.
4. Sensor from engine
INSPECT
Sensor O-ring for wear, cracks or leakage. Replace if necessary. Lube new O-ring with engine oil before installing.
INSTALL OR CONNECT
1. Sensor in engine.
2. Sensor bolt, tighten to 25 Nm (17 lb. ft.).
3. Sensor electrical connector.
4. Negative battery cable.
NOTE: The procedure, called the TDC Offset Program Procedure, utilizes the capabilities of the Tech 1 scan tool. This procedure must he done
when a crankshaft position sensor is replaced. Refer to TDC Offset Program Procedure. See: Powertrain Management/Computers and Control
Systems/Engine Control Module/Service and Repair