C 2500 Truck 2WD V8-454 7.4L VIN N TBI (1995)
INSTALL OR CONNECT
TOOLS REQUIRED:
^
J 29193 Steering Linkage Installer (12 mm).
1. Pitman arm on the pitman shaft. Line up the marks made at removal.
2. Pitman arm washer and nut.
TIGHTEN
^
Pitman arm nut to 250 Nm (184 lbs. ft.).
3. Relay rod (14) to the pitman arm ball stud (5). Make sure the seal is on the stud.
^
Tighten J 29193 or J 29194 to 62 Nm (48 lbs. ft.) to seat the tapers. Remove the tool.
4. New relay rod prevailing torque nut (11) to the pitman arm ball stud (5).
TIGHTEN
^
Nut (11) to 70 Nm (52 ft.lbs.).
5. Lower the vehicle.