C 2500 Yukon XL 2WD V8-6.0L VIN U (2001)
Installation Procedure
1. Lightly lubricate the new O-ring with transmission fluid.
2. Install the speed sensor to the transmission.
3. Install the speed sensor bolt.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the VSS bolt.
^
Tighten the VSS Bolt to 10 Nm (88 inch lbs.).
5. Connect the electrical connector to the VSS.
6. Lower the vehicle.
4L60-E - Automatic Transmission
Vehicle Speed Sensor (VSS) Replacement
Removal Procedure
1. Remove the harness connector.
2. Remove the bolt (2).
3. Remove the vehicle speed sensor (1).
4. Remove the O-ring seal (3).
Installation Procedure