C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
Air Bag(s) Arming and Disarming: Service and Repair
Disabling
IMPORTANT: Refer to SIR Service Precautions before disabling the SIR system.
1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
IMPORTANT: With the AIR BAG Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not
indicate an SIR system malfunction.
4. Remove the AIR BAG Fuse from the fuse block.
5. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 2-way connector (2) located at the base of the steering
column.
6. Disconnect the steering wheel module yellow 2-way connector (2) located at the base of the steering column.
7. Access the IP module yellow 2-way connector (1) located behind the IP module (2) by removing the upper IP trim panel. Refer to Trim Pad
Replacement - IP Upper in Instrument Panel, Gauges and Warning Indicators.
8. Remove the CPA from the IP module yellow 2-way connector (1) located behind the IP module (2).
9. Disconnect the IP module yellow 2-way connector (1) located behind the IP module (2).