C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
7. Remove the hoses from the pump.
8. For vehicles with variable effort steering, disconnect the electrical connector.
9. Remove the pump from the vehicle.
10. Remove the rear bracket from the power steering pump.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the rear bracket to the power steering pump.
Tighten the rear bracket retaining bolts to 50 Nm (37 ft. lbs.).
2. Install the power steering pump to the vehicle.
3. Install the hoses to the pump.
Tighten the hose fitting to 28 Nm (20 ft. lbs.).
4. For vehicles with variable effort steering, connect the electrical connector.
5. Install the bolts (1) to the rear of the power steering pump.
Tighten the rear bolts to 50 Nm (37 ft. lbs.).
6. Install the power steering pump mounting bracket.
Tighten the mounting bracket bolts to 46 Nm (34 ft. lbs.).
7. Install the power steering pump (1) to the bracket.
8. Install the bolts (2) to the front of the pump.
Tighten the power steering pump retaining bolts to 50 Nm (37 ft. lbs.).