C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
1. Install the upper control arm.
2. Install the upper control arm retaining bolt and nut to the axle bracket.
3. Install the upper control arm retaining bolt to the frame bracket.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the upper control arm retaining nut.
Tighten the upper control arm retaining bolts to 105 Nm (77 ft. lbs.).
5. Connect the (RTD) sensor (if equipped).
6. Lower the vehicle.
Rear Axle Lower Control Arm Replacement
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the lower control arm retaining nuts.
3. Remove the lower control arm retaining bolt.
4. Remove the lower control arm.
Installation Procedure