C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
18. Remove the cable grommet from the floor panel.
19. Raise the vehicle. Refer to Vehicle Lifting.
20. Remove the two clips on the cable from the floor panel reinforcement.
21. Remove the cable from the clips on the transfer case, if equipped.
22. Remove the front half (column end) of the range selector cable assembly from the vehicle.
Installation Procedure
1. Route the cable through the hole in the floor panel.
2. Install the cable to the clips on the transfer case, if equipped.
3. Install the two clips on the cable to the floor panel reinforcement.
4. Lower the vehicle.
5. Ensure that the steering column shift lever is in the park position.
6. Install the cable grommet to the floor panel.