C 2500 Yukon XL 2WD V8-8.1L VIN G (2002)
Important: Do not reuse the existing E-clip. Discard the removed E-clip.
8. Ensure that the steering column shift lever remained in the park position for the best possible access to the E-clip. Remove the E-clip by pulling
radially on the center section of the E-clip.
9. Pull the range selector cable center connector ends apart.
10. Remove the retainer that secures the cable to the bracket.
11. Depress the tangs and remove the cable from the bracket.
12. Remove the cable to from the clips on the transfer case, if equipped.
13. Remove the rear half (transmission end) of the range selector cable from the vehicle.
Installation Procedure
1. Install the rear half transmission end of the range selector cable to the vehicle.
2. Install the cable to the clips on the transfer case, if equipped.