C 3500 Truck 2WD V8-379 6.2L DSL (1986)
B.
Spray wheel with Amchem #33 or equivalent let soak 1 to 3 minutes, then rinse with water and blow dry.
C.
Spray wheel with Amchem #1001 or equivalent let soak 1 to 3 minutes, then rinse with water and blow dry.
D.
Mask off the tire prior to performing steps E and F.
E.
Finish with Ditzler delclear acrylic urethane and Ditzler ultra urethane additive or equivalent. Three coats.
1ST. COAT - LIGHT MIST COAT, LET FLASH 2ND. COAT - LIGHT, LET FLASH 3RD. COAT - HEAVY DOUBLE WET COAT
CAUTION:
IT IS MANDATORY THAT ADEQUATE RESPIRATORY PROTECTION BE WORN.
EXAMPLES OF SUCH PROTECTION ARE: AIR LINE RESPIRATORS WITH FULL HOOD OR HALF MASK, IF NOT
AVAILABLE USE A VAPOR/PARTICULATE RESPIRATOR THAT RESPIRATOR
MANUFACTURER RECOMMENDS AS EFFECTIVE FOR ISOCYANATE VAPORS
AND MISTS (UNLESS LOCAL REGULATIONS PREVAIL).
F.
Let dry for 24 hours--(or flash for 30 minutes, force dry at 140 degrees for 30 minutes, and allow to cool for 30 minutes before mounting.
V.
WHEEL INSTALLATION
A.
Rebalance tire/wheel assemblies by replacing the original balance weights with nylon-coated weights.
B.
Install tire/wheel assembly on car.
REQUIRED MATERIALS
Amchem Alumi prep #33 - stock #DX533 (or equivalent) - cleaning and conditioning chemical for aluminum.
Amchem Alodine #1001 - stock #DX501 (or equivalent) - coating chemical for aluminum.
Ditzler Delclear acrylic urethane clear - stock #DAU-75 (or equivalent).
Ditzler Delthane ultra-urethane additive - stock #DXR-80 (or equivalent).
Nylon-coated weights--these are available from WDDGM in 1/4 ounce increments ranging from 1/4 ounce to 3 ounces, P/N 9591358 through 9591367
inclusively.
Labor Operation Number:
T1170
Labor Time
:
1.7 hours (each wheel)
Material Allowance
:
$3.75 (per wheel)