Front Wheel Speed Sensor Replacement for C3500 HD Truck
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor (Exc. C3500 HD)
FRONT WHEEL SPEED SENSOR REPLACEMENT
REMOVE OR DISCONNECT
1. Tire and wheel.
2. Brake caliper.
3. Hub and rotor.
4. Wheel speed sensor electrical connector.
5. Wheel speed sensor harness clip rivets.
^
Use a 3/16 inch drill.
6. Clips from wheel speed sensor wire.
^
Save clips for new wheel speed sensor.
7. Wheel speed sensor mounting bolts and nut.
8. Splash shield mounting bolts.
9. Wheel speed sensor and splash shield.
10. Splash shield gasket.
INSTALL OR CONNECT
FASTENER NOTICE
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants,
or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may
damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
1. Splash shield gasket.
2. Wheel speed sensor and splash shield.
3. Splash shield mounting bolts.
TIGHTEN
^
Splash shield bolts to 16 Nm (12 lbs. ft.).
4. Wheel speed sensor mounting bolts and nut.
TIGHTEN
^
Wheel speed sensor mounting bolts to 26 Nm (19 lbs. ft.).
5. Harness clips on wheel speed sensor wire.
^
Locate clips at paint dots on wire.
6. Harness clips and 3/16 inch rivets.
7. Wheel speed sensor electrical connector.
8. Hub and rotor.
9. Brake caliper.
10. Tire and wheel.
