C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
Brake Caliper: Service and Repair
Brake Caliper Mounting Plate Replacement (C3500HD (Front))
Use the brake caliper mounting plate in order to mount all of the stationary brake components. An L or R following the part number cast on the back
of the plates indicates left or right side mounting. Some plates may also have an L or R painted on the front.
REMOVAL PROCEDURE
1. Apply the parking brake.
2. Block the wheels.
3. Remove the brake caliper (3).
4. Remove the hub and brake rotor (7) assembly.
5. Wheel Hub, Bearing, and Seal Replacement.
6. Remove the bolts (2) and washers.
7. Remove the brake caliper mounting plate.
8. Inspect the support rails for rust, corrosion, and wear.
9. Clean the support rails with a wire brush.
10. Inspect the brake caliper mounting plate for cracks or elongated bolt holes. Replace the mounting plate if necessary.
INSTALLATION PROCEDURE
1. Install the brake caliper mounting plate to the steering knuckle.
IMPORTANT: Ensure that the threads are clean and greaseless before applying threadlocker.
2. Apply 2720 threadlocker to the threads of each brake caliper mounting plate bolt.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the bolts and washers.
^
Tighten the brake shield (1) bolts to 26 Nm (19 ft. lbs.).