C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
Engine Accessory Bracket: Service and Repair
Accessory Mounting Brackets Replacement (Generator)
REMOVAL PROCEDURE
1. Remove the engine cooling fan. Refer to Fan Clutch Replacement in Cooling System.
2. Disconnect the battery negative cable. Refer to Battery Cable in Powertrain Management.
3. Remove the drive belt. Refer to Drive Belt Replacement.
4. Remove the generator. Refer to Generator Replacement (CS 144) in Starting and Charging.
5. Remove the wire harness bracket from the generator mounting bracket.
6. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement.
7. Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement.
8. Remove the three bolts and nut holding the generator bracket to the engine.
9. Slide the bracket off of the stud.
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Service Precautions.