C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
Notice: Do not hammer the camshaft sprocket onto the camshaft. To do so may dislodge the rear camshaft plug and damage the camshaft.
2. Install the timing chain and sprocket to the camshaft.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
3. Install the camshaft retaining bolts to the camshaft.
Tighten
Tighten the retaining bolts to 30 N.m (22 lb ft).
4. Install the timing chain and sprocket to the camshaft.
5. Install the engine front cover to the engine block.
6. Install a new crankshaft position reluctor ring to the crankshaft.
7. Install the crankshaft balancer to the crankshaft.
8. Install the water pump to the engine block.
9. Install the lower fan shroud to the radiator.
10. Lower the vehicle.
11. Install the drive belt on the vehicle drive pulleys.
12. Install the upper fan shroud to the radiator.
13. Connect the battery negative cable to the battery.
