C Yukon 2WD V8-5.7L VIN R (1999)
Tighten the trim panel armrest screw to 2 N.m (18 lb in).
9. Insert the screw cover.
10. Install the trim panel upper extension.
11. Install the door handle bezel.
12. Connect the negative battery cable.
Trim Panel
Removal Procedure
Tool Required:
J 38778 Trim Panel Remover
1. Disconnect the negative battery cable.
2. Remove the door handle bezel.
3. Remove the window regulator handle, as necessary.
4. Disconnect the power accessory switch mounting panel wiring connector, as necessary.
5. Remove the trim panel upper extension.
6. Using a flat blade tool, carefully pry off the trim panel armrest screw cover in order to access the screw.
7. Remove the trim panel armrest screw.
8. Using the J 38778, carefully pry the retainer from the retainer seats.
9. Disconnect the courtesy light connector, if necessary.
10. Remove the trim panel from the door.
11. Remove the courtesy lamp lens or the reflector.
12. Pull the retainers from the slot in the trim panel.
13. Remove the retainers.
Installation Procedure