C Yukon 2WD V8-5.7L VIN R (1999)
7. Remove the booster to bulkhead nuts.
8. Remove the booster assembly.
9. Remove the gasket.
INSTALLATION PROCEDURE
1. Install the gasket.
2. Install the booster assembly.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the booster to bulkhead nuts.
^
Tighten the nuts to 36 Nm (26 ft. lbs.).
4. Install the stoplamp switch and pushrod.
5. Install the master cylinder and bracket.