C Yukon 2WD V8-5.7L VIN R (1999)
2. Remove the right rear quarter trim panel.
3. Disconnect the electrical connectors, as necessary.
4. Remove the screws (4) securing the blower motor resistor (5).
5. Remove the blower motor resistor.
INSTALLATION PROCEDURE
1. Install the blower motor resistor (5).
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the screws (4) in order to secure the blower motor resistor.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
3. Connect the electrical connectors, as necessary.
4. Install the right rear quarter trim panel.
5. Connect the negative battery cable.
6. Test the circuit operation.
