C Yukon 2WD V8-5.7L VIN R (1999)
1. Install the sensor into the timing cover. Lube the O-ring with clean engine oil before installing.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the sensor hold down bolt.
Tighten
Tighten the hold down bolt to 8 N.m (71 lb in).
3. Install the CKP sensor harness connector.
4. Lower the vehicle.
5. Connect the negative battery cable.
6. Perform the CKP System Variation Learn Procedure. See: Testing and Inspection