C Yukon 2WD V8-5.7L VIN R (1999)
1. Install the upper ball joint into the knuckle.
2. Install the lower ball joint into the knuckle.
3. Install the knuckle seal.
4. Install the splash shield to the knuckle.
5. Install the bolts to the splash shield.
-
Tighten the bolts to 26 Nm (19 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the tie rod end into the knuckle.
7. Install the hub/rotor assembly.
8. Adjust the wheel bearings.
9. Install the tire and wheel assembly.
10. Remove the floor stands.
11. Lower the vehicle.
12. Check the front wheel alignment.