Canyon 2WD L4-2.9L (2008)
Engine Block Heater: Service and Repair
Coolant Heater Replacement
Coolant Heater Replacement (LLV - 2.9L,LLR - 3.7L)
Removal Procedure
1. Raise and support the vehicle only high enough to access the coolant heater (6) through the wheelhouse. Refer to Lifting and Jacking the Vehicle (
See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
3. Disconnect the coolant heater cord (4) from the coolant heater (6).
4. Remove the coolant heater from the engine block.
Installation Procedure
1. Locate the block heater hole on side of block.
2. While lining up the retaining clip on the block heater to notch on block, insert the block heater and snap into place.