Canyon 2WD L4-2.9L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the multifunction turn signal switch bolts.
Tighten the bolts to 7 N.m (62 lb in).
3. Route the wire harness assembly down the steering column.
4. Connect any electrical connectors and install the wiring harness through any retainers as needed.
5. Remove the centering tab from the multifunction turn signal switch.
6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Trim Covers Replacement) .
7. Install the steering wheel. Refer to Steering Wheel Replacement (See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Wheel Replacement) .
