Canyon 2WD L4-2.9L (2008)
7. Connect the electrical connector (3) to the switch (4).
8. Install the transmission control lever to the manual shaft with the nut.
Tighten the control lever nut to 20 N.m (15 lb ft).
9. Lower the vehicle.
10. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment (See: Shift Linkage/Shift
Cable/Adjustments) .
11. Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only. If proper operation of the switch
can not be obtained, replace the switch.