Canyon 2WD L4-2.9L (2008)
8. Remove the left hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side (See: Body and Frame/Interior Moulding
/ Trim/Trim Panel/Service and Repair) .
9. Pull the drivers side carpet up, enough to access the range selector cable.
10. Disconnect the range selector cable retainer (2) from the lower dash panel (1).
11. Complete the following in order to disconnect the range selector cable (4) from the transmission range selector lever ball stud (1).
1. Insert a flat bladed tool between the range selector cable end (2) and the range selector lever.
2. Pry the range selector cable end (2) away from the range selector lever.
12. Remove the retainer (3) from the range selector cable (4).
13. Push the range selector cable locking tabs inward toward each other to release from the steering column bracket (5).
14. Remove the range selector cable (4) from the vehicle.
Installation Procedure