Canyon 2WD L4-2.9L (2008)
1. Slide the clutch pedal position switch (3) with retaining plate (2) into the clutch pedal bracket (1), until the locking tabs (2) are fully engaged.
2. Connect the electrical connector (2) to the clutch pedal position switch (1).
3. Complete the following in order to adjust the clutch pedal position switch (1).
1. Push the switch fully into the bracket, allowing the switch to ratchet in the retaining plate.
2. Depress the clutch pedal all the way to the floor.
Warning
Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn
procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the
vehicle is in gear and the starter motor is accidentally engaged.
4. Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn (See: Manual
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Clutch Pedal Position Sensor Learn) .
