Canyon 2WD L5-3.5L VIN 6 (2004)
2.
Install fixture EN 45680-401/cylinder bore sleeve installer EN 45680-403 assembly (1), which is part of EN 45680-400, over the cylinder bore
sleeve (117) and onto the cylinder block. Do not apply downward pressure to the cylinder bore sleeve (117).
Important:
Use 4 old cylinder head bolts for the attaching bolts.
3.
Insert the 4 attachment bolts into the legs of the fixture EN 45680-401(1).
Note:
Refer to Fastener Notice in Cautions and Notices.
4.
Tighten the 4 attachment bolts. Do not apply downward pressure to the cylinder bore sleeve (117).
Tighten
Tighten the 4 attachment bolts to 15 N.m (11 lb ft).
5.
Align the bottom of the cylinder bore sleeve (117) with the cylinder bore of the block (100).