Canyon 2WD L5-3.5L VIN 6 (2004)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the engine wiring harness electrical connector (1) from the oil pressure switch (2).
3. Remove the engine oil pressure switch.
Installation Procedure
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
1. Install the engine oil pressure switch.
^
Tighten the oil pressure switch to 20 Nm (15 ft. lbs.).