Canyon 2WD L5-3.5L VIN 6 (2004)
Important:
^
To aid in aligning the sprocket to the camshaft, use a 25 mm (1 inch) wrench on the hex of the camshaft to rotate
^
Ensure the alignment pin is properly engaged with the camshaft
2. Install the intake camshaft sprocket onto the intake camshaft.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the new intake camshaft sprocket bolt.
3.1.
Tighten the intake camshaft sprocket bolt to 20Nm(15ft. lbs.).
3.2.
Use the J 45059 to rotate the intake camshaft sprocket bolt an additional 1 00 degrees.
4. Remove the J44217 (1) and EN-44217-45 (1).
5. Remove the J 44221 from the camshafts.
6. Install the intake Camshaft Position (CMP) sensor.
7. Install the camshaft cover.